2 gün önce sandisk ssd plus 240 gb aldım taktım bilgisayarıma. Fakat hızı beni tatmin etmedi. Forumda arama yaptım ve https://forum.ubuntu-tr.net/index.php?topic=53076.0 (https://forum.ubuntu-tr.net/index.php?topic=53076.0) bu konuya rastladım. iyiki de rastlamışım. oradaki verilen çıktıları deniyordum ki ne göreyim. Benim ssd'nin de okuma hızı çok düşük. O konuya cevaben istenilen çıktıları kendi bilgisayarımda denerken bi şok daha geçirdim. Bilgisayarımın RAM'leri DDR4 fakat 1200 mhz olarak görünüyor. Bu işte bir terslik yok mu ? Bilgisayarımın modeli Lenovo ideapad 310 (amd modeli) alalı 2-3 ay oldu. İlgili çıktıları aşağıya geçiyorum beni bilgilendirirseniz çok memnun olurum.
sudo hdparm -Tt /dev/sda
/dev/sda:
Timing cached reads: 3876 MB in 2.00 seconds = 1940.18 MB/sec
Timing buffered disk reads: 1056 MB in 3.00 seconds = 351.76 MB/sec
cat /sys/devices/virtual/dmi/id/board_{vendor,name}
LENOVO
Toronto 5B1
sudo lshw -C memory
*-cache:0
açıklama: L1 önbellek
physical id: 22
slot: L1 Cache
boyut: 320KiB
kapasite: 320KiB
saat: 1GHz (1.0ns)
kapasiteler: pipeline-burst internal write-back unified
yapılandırma: level=1
*-cache:1
açıklama: L2 önbellek
physical id: 23
slot: L2 Cache
boyut: 2MiB
kapasite: 2MiB
saat: 1GHz (1.0ns)
kapasiteler: pipeline-burst internal write-back unified
yapılandırma: level=2
*-memory
açıklama: Sistem Belleği
physical id: 24
slot: System board or motherboard
boyut: 12GiB
*-bank:0
açıklama: SODIMM Eşzamanlı 1200 MHz (0,8 ns)
ürün: M471A1K43BB1-CRC
üretici: Samsung
physical id: 0
serial: 33DDEFCA
slot: DIMM 0
boyut: 8GiB
genişlik: 64 bits
saat: 1200MHz (0.8ns)
*-bank:1
açıklama: SODIMM Eşzamanlı 1200 MHz (0,8 ns)
ürün: 4ATF51264HZ-2G3AZ
üretici: Micron
physical id: 1
serial: 00000000
slot: DIMM 1
boyut: 4GiB
genişlik: 64 bits
saat: 1200MHz (0.8ns)
*-firmware
açıklama: BIOS
üretici: LENOVO
physical id: 0
sürüm: 1LCN32WW
date: 09/05/2016
boyut: 128KiB
kapasite: 8128KiB
kapasiteler: pc_ upgrade shadowing cdboot bootselect edd int5printscreen int9keyboard int14serial int17printer int10video acp_ usb biosbootspecification netboot uefi
sudo hdparm -I /dev/sda
/dev/sda:
ATA device, with non-removable media
Model Number: SanDisk SDSSDA240G
Serial Number: 170816443410
Firmware Revision: Z32080RL
Media Serial Num:
Media Manufacturer:
Transport: Serial, ATA8-AST, SATA 1.0a, SATA II Extensions, SATA Rev 2.5, SATA Rev 2.6, SATA Rev 3.0
Standards:
Used: unknown (minor revision code 0x0110)
Supported: 9 8 7 6 5
Likely used: 9
Configuration:
Logical max current
cylinders 16383 16383
heads 16 16
sectors/track 63 63
--
CHS current addressable sectors: 16514064
LBA user addressable sectors: 268435455
LBA48 user addressable sectors: 468862128
Logical Sector size: 512 bytes
Physical Sector size: 512 bytes
Logical Sector-0 offset: 0 bytes
device size with M = 1024*1024: 228936 MBytes
device size with M = 1000*1000: 240057 MBytes (240 GB)
cache/buffer size = unknown
Form Factor: 2.5 inch
Nominal Media Rotation Rate: Solid State Device
Capabilities:
LBA, IORDY(can be disabled)
Queue depth: 32
Standby timer values: spec'd by Standard, no device specific minimum
R/W multiple sector transfer: Max = 1 Current = 1
Advanced power management level: 254
DMA: mdma0 mdma1 mdma2 udma0 udma1 udma2 udma3 udma4 udma5 *udma6
Cycle time: min=120ns recommended=120ns
PIO: pio0 pio1 pio2 pio3 pio4
Cycle time: no flow control=120ns IORDY flow control=120ns
Commands/features:
Enabled Supported:
* SMART feature set
Security Mode feature set
* Power Management feature set
* Write cache
* Look-ahead
* Host Protected Area feature set
* WRITE_BUFFER command
* READ_BUFFER command
* DOWNLOAD_MICROCODE
* Advanced Power Management feature set
SET_MAX security extension
* 48-bit Address feature set
* Device Configuration Overlay feature set
* Mandatory FLUSH_CACHE
* FLUSH_CACHE_EXT
* SMART error logging
* SMART self-test
* General Purpose Logging feature set
* WRITE_{DMA|MULTIPLE}_FUA_EXT
* 64-bit World wide name
* WRITE_UNCORRECTABLE_EXT command
* {READ,WRITE}_DMA_EXT_GPL commands
* Segmented DOWNLOAD_MICROCODE
* Gen1 signaling speed (1.5Gb/s)
* Gen2 signaling speed (3.0Gb/s)
* Gen3 signaling speed (6.0Gb/s)
* Native Command Queueing (NCQ)
* Phy event counters
* READ_LOG_DMA_EXT equivalent to READ_LOG_EXT
* DMA Setup Auto-Activate optimization
Device-initiated interface power management
* Software settings preservation
Device Sleep (DEVSLP)
* DOWNLOAD MICROCODE DMA command
* WRITE BUFFER DMA command
* READ BUFFER DMA command
* Data Set Management TRIM supported (limit 8 blocks)
* Deterministic read ZEROs after TRIM
Security:
Master password revision code = 65534
supported
not enabled
not locked
frozen
not expired: security count
supported: enhanced erase
2min for SECURITY ERASE UNIT. 2min for ENHANCED SECURITY ERASE UNIT.
Logical Unit WWN Device Identifier: 5001b444a60fec58
NAA : 5
IEEE OUI : 001b44
Unique ID : 4a60fec58
Device Sleep:
DEVSLP Exit Timeout (DETO): 90 ms (drive)
Minimum DEVSLP Assertion Time (MDAT): 26 ms (drive)
Checksum: correct
HDD okuma yazma hızı pc hızına da bağlıdır bunun için en iyi test iyi bir masa üstü pc de test etmektir.
Yani HDD okuma yazma İşmeci ve anakart vs vs sistemin hızlı olması gerekir.
@alicin, bakındım böyle bir problem göremedim. Farklı dağıtımda veya windows üzerinde denedin mi ?
@mustangank, masaüstü veya dizüstü ile alakası yok olayın.
Yok hocam denemedim. Ama hdd nin yedeğini harici hdd me systemback ile alıp, ssd yi taktım ve o yedeği ssd ye yükledim. Hiç problem çıkarmadı herşeyi çalışıyor. Hal böyle olunca trim özelliğini kendim aktif etmek zorunda kaldım tabi. Bu arada 2400 mhz ddr4 ramlerin 1200 mhz görünmesi normalmiş.
Ram konusunda ben de öyle düşündüm ama kendi sistemimde ddr3 1600 mhz ram var ve tam hızını gösteriyor.
Bi kaç yerde okudum herkes normal demiş. Dual falan muhabbetleri geçmiş bende anlamadım doğrusu